No Products in the Cart
Metal Heat Transfer Vinyl
Application Instructions
Cutter Settings
Cricut:
Blade: Standard
Setting: Iron-On
Silhouette Cameo:
Blade: Standard, 2
Material: Heat Transfer, Smooth
Speed: 8
Force: 6
Scan N Cut:
Blade: Standard, 2
Cut Speed: 1
Cut Pressure: 3
Roland GS/GX-24:
Blade: 45°
Gram Force: 80-90
Offset: .250
Speed: 30 cm/s
Graphtec:
Blade: 45°
Gram Force: 8-9
Tool: CB09U+0
Speed: 30 cm/s
MH, SC2, LP3, and Titan 1:
Blade: 45°/60°
Gram Force: 85-90
Speed: 300mm/s
*Blade Advancing Varies
Titan 2 & 3:
Blade: 45°/60°
Gram Force: 65-70
Speed: 300mm/s
*Blade Advancing Varies
Siser Metal HTV heat press settings may vary based on blade condition and age of machine. Always perform a test cut prior to cutting designs.
Application Instructions
Application instructions (home iron)
- Set iron dial between Cotton and Linen
- Cover design with PTFE Teflon Sheet
- Place on flat, hard surface (ironing board not recommended)
- Press iron with medium/firm pressure (do not slide iron)
- Press each section of design for 10-15 seconds
- If areas of design lift after application, replace Teflon sheet and re-press for 5-10 seconds
- Peel carrier cold
Application Instructions (heat press)
- Cut in reverse
- Weed excess material
- Preheat garment for 2-3 seconds
- Apply design at 305°F/150°C
- Use medium pressure for 10-15 seconds
- Peel carrier cold
Recommended Accessories & Care
Metal Applies to:
100% cotton
Poly/cotton blends
100% polyester
Recommended Accessories:
Laundering:
Wait 24 hours before 1st wash
Machine wash cold / mild detergent
Hang item to dry
Do not dry clean