PARART™ 3D Puff Heat Transfer Vinyl

Add a fun 3D look to any design

3D Puff HTV is available in over 30 colours — the most puff colours in the industry. It's easy to use: you only need to press once to get the puff effect. It weeds easily, and its pressure-sensitive carrier allows for repositioning. Available in Standard, Metallic, Glitter, and Glow In The Dark.

Applies to: cotton, uncoated polyester, fabric blends, polyester/acrylic, and similar fabrics. Not suitable for nylon.

Application instructions

Cutting (all types)

• Blade: 45°
• Cut the puff vinyl side up. Do not cut through the carrier sheet.
• Mirror your image.

Standard and Glow In The Dark

• Temp: 280–295°F — temperature varies between colour batches, so a test press is strongly recommended.
• Pressure: strong and firm. 3D Puff needs more pressure than any other HTV we've pressed — a Cricut EasyPress is not recommended.
• Time: 8–15 seconds
• Peel: warm

Glitter

• Temp: 285°F
• Pressure: strong and firm
• Time: 3–5 seconds to adhere, remove the carrier sheet, then cover and press a further 7–10 seconds
• Peel: warm

Metallic — two-press application

• Temp: 300°F — run a test press first.
• Pressure: strong and firm. A heat press is required.
• Press 1: 3 seconds, then peel the carrier once the HTV is warm. Peeling while hot may lift the vinyl from the garment.
• Press 2: cover with a Teflon sheet and press again to finish.

Also available: Parart Glitter 3D Puff HTV and Parart Dollar HTV.

Watch: pressing PARART 3D Puff