EasyWeed Stretch HTV Application Instructions
Cutter Settings
Cricut
- Blade: Standard
- Setting: Iron-on
Silhouette Cameo
- Blade: Standard, 3
- Material: Heat Transfer, Smooth
- Speed: 8
- Force: 6
Scan N Cut
- Blade: Standard, 2
- Cut Speed: 1
- Cut Pressure: 1
Roland GS/GX-24
- Blade: 45°
- Gram Force: 60-70
- Offset: .250
- Speed: 30 cm/s
Graphtec
- Blade: 45°
- Gram Force: 9-10
- Tool: CB09U+0
- Speed: 30 cm/s
MH, SC2, LP3, and Titan 1
- Blade: 45°/60°
- Gram Force: 80-85
- Speed: 300mm/s
- *Blade advancing varies
Titan 2 & 3
- Blade: 45°/60°
- Gram Force: 60-65
- Speed: 300mm/s
- *Blade advancing varies
Settings may vary based on blade condition and the age of the machine. Always perform a test cut prior to cutting designs.
Siser EasyWeed Stretch Heat Press Settings & Application Instructions
Home iron
- Set iron dial between Cotton and Linen
- Cover design with PTFE Sheet for HTV
- Place on a flat, hard surface (ironing board not recommended)
- Press iron with medium/firm pressure (do not slide iron)
- Press each section of the design for 10-15 seconds
- If areas of design lift after application, replace Teflon sheet and re-press for 5-10 seconds
- Peel carrier hot or cold
Heat press
- Cut in reverse
- Weed excess material
- Preheat garment for 2-3 seconds
- Apply design at 320°F/160°C
- Use firm pressure for 20 seconds
- Peel carrier hot or cold
Recommended Accessories & Care
EasyWeed Stretch applies to
- 100% cotton
- Poly/cotton blends
- 100% polyester
- Leather
- Lycra®/Spandex
Recommended accessories
Laundering
- Wait 24 hours before 1st wash
- Machine wash warm or cold / mild detergent
- Dry on normal dryer setting
- Do not dry clean