EasyWeed Adhesive Application Instructions

Blade: Standard
Setting: Iron-On

Blade: Standard, 3
Material: Heat Transfer, Smooth
Speed: 8
Force: 6

Blade: Standard, 2
Cut Speed: 1
Cut Pressure: 1

Blade: 45°
Gram Force: 80-90
Offset: .250
Speed: 25-50 cm/s

Blade: 45°
Gram Force: 9-10
Tool: CB09U+0
Speed: 30 cm/s

Blade: 45°/60°
Gram Force: 80-85
Speed: 300mm/s
*Blade Advancing Varies

Blade: 45°/60°
Gram Force: 60-65
Speed: 300mm/s
*Blade Advancing Varies

Settings may vary based on blade condition and age of machine. Always perform a test cut prior to cutting designs.

Set iron dial between Cotton and Linen
Cover design with PTFE Teflon Sheet
Place on flat, hard surface (ironing board not recommended)
Press iron with medium/firm pressure (do not slide iron)
Press each section of design for 10-15 seconds
If areas of design lift after application, replace Teflon sheet and re-press for 5-10 seconds
Peel carrier hot

100% cotton
Poly/cotton blends
100% polyester

Wait 24 hours before 1st wash
Machine wash cold / mild detergent
Dry on normal dryer setting
Do not dry clean

title