Brick 600 HTV Application Instructions
Siser Brick 600 Cutter Settings
Cricut
- Blade: Standard
- Setting: Cardstock Light+
Silhouette Cameo
- Blade: Standard, 10
- Material: Heat Transfer, Flocked
- Speed: 4
- Force: 33
Scan N Cut
- Blade: Standard, 10
- Cut Speed: 1
- Cut Pressure: 2
Roland GS/GX-24
- Blade: 60°*
- Gram Force: 150-190
- Offset: .250
- Speed: 30 cm/s
Graphtec
- Blade: 60°*
- Gram Force: 11-12
- Tool: CB09U+0
- Speed: 25 cm/s
MH, SC2, LP3, and Titan 1
- Blade: 45°/60°
- Gram Force: 120-130
- Speed: 300mm/s
- *Blade advancing varies
Titan 2 & 3
- Blade: 45°/60°
- Gram Force: 100-110
- Speed: 300mm/s
- *Blade advancing varies
Settings may vary based on blade condition and age of machine. Always perform a test cut prior to cutting designs. * For Roland & Graphtec cutters, due to the material thickness, extend the blade out so that a significant amount of blade is exposed.
Application Instructions
Home iron
- Set iron dial between Cotton and Linen
- Cover design with PTFE Teflon Sheet
- Place on flat, hard surface (ironing board not recommended)
- Press iron with medium/firm pressure (do not slide iron)
- Press each section of design for 10-15 seconds
- If areas of design lift after application, replace Teflon sheet and re-press for 10 seconds
- Peel carrier cold
Heat press
- Cut in reverse
- Weed excess material
- Preheat garment for 2-3 seconds
- Apply design at 310°F/155°C
- Use medium/firm pressure for 20 seconds
- Peel carrier cold
Recommended Accessories & Care
Brick 600 applies to
- 100% cotton
- Poly/cotton blends
- 100% polyester
Recommended accessories
Laundering
- Wait 24 hours before 1st wash
- Machine wash cold / mild detergent
- Dry on low dryer setting
- Do not dry clean