Save up to 25% on Vinyl Bundles Thru The Weekend | Click here for discount code
  • (404) 720-5656
  • Mon - Fri 9AM - 6:30PM, Sat 9AM - 3PM
  • 925 Veterans Memorial Hwy SW, #150, Mableton, GA

BlackBoard Heat Transfer Vinyl
Application Instructions

Cutter Settings

Cricut:

Blade: Standard
Setting: Paper

Silhouette Cameo:

Blade: Standard, 3
Material: Heat Transfer, Smooth
Speed: 5 
Thickness: 8

Scan N Cut:

Blade: Standard, 2
Cut Speed: 1
Cut Pressure: 1

Roland GS/GX-24:

Blade: 45°
Gram Force: 70-80
Offset: .250
Speed: 50 cm/s

Graphtec:

Blade: 45°
Gram Force: 7-8 
Tool: CB09U+0
Speed: 50 cm/s

MH, SC2, LP3, and Titan 1:

Blade: 45°/60°
Gram Force: 80-85
Speed: 300mm/s
*Blade Advancing Varies

Titan 2 & 3:

Blade: 45°/60°
Gram Force: 60-65
Speed: 300mm/s
*Blade Advancing Varies

Settings may vary based on blade condition and age of machine. Always perform a test cut prior to cutting designs.

Application Instructions

Application instructions (home iron)

  • Set iron dial between Cotton and Linen
  • Cover design with PTFE Teflon Sheet
  • Place on flat, hard surface (ironing board not recommended)
  • Press iron with medium/firm pressure (do not slide iron)
  • Press each section of design for 10-15 seconds
  • If areas of design lift after application, replace Teflon sheet and re-press for 10 seconds
  • Peel carrier hot or cold
  • Cover completed design and press for 5-10 seconds

Application Instructions (heat press)

  • Cut in reverse
  • Weed excess material
  • Preheat garment for 2-3 seconds
  • Apply design at 275°F/135°C
  • Use light/medium pressure for 15 seconds
  • Peel carrier warm or cold

Recommended Accessories & Care

BlackBoard Applies to:

100% cotton
Poly/cotton blends
100% polyester

Laundering:

Wait 24 hours before 1st wash
Machine wash cold / mild detergent
Dry on normal dryer setting
Do not dry clean

BACK TO TOP