Glitter Heat Transfer Vinyl
Application Instructions

Cricut:

Blade: Standard
Setting: Iron-on+

Silhouette Cameo:

Blade: Standard, 4 
Material: Heat Transfer, Smooth
Speed: 8
Force: 11 

Scan N Cut:

Blade: Standard, 3 
Cut Speed: 1
Cut Pressure: 5

Roland GS/GX-24:

Blade: 45°
Gram Force: 180-190 
Offset: .250
Speed: 30 cm/s

Graphtec:

Blade: 45°
Gram Force: 17 
Tool: CB09U+0
Speed: 30 cm/s

MH, SC2, LP3, and Titan 1:

Blade: 45°/60°
Gram Force: 120-130 
Speed: 300mm/s
*Blade Advancing Varies

Titan 2 & 3:

Blade: 45°/60°
Gram Force: 100-110 
Speed: 300mm/s
*Blade Advancing Varies

Application instructions (home iron)

• Set iron dial between Cotton and Linen
• Cover design with PTFE Teflon Sheet
• Place on flat, hard surface (ironing board not recommended)
• Press iron with medium/firm pressure (do not slide iron)
• Press each section of design for 10-15 seconds
• If areas of design lift after application, replace Teflon sheet and re-press for 10 seconds
• Peel carrier warm

Application Instructions (heat press)

• Cut in reverse
• Weed excess material
• Preheat garment for 2-3 seconds
• Apply design at 320°F/160°C
• Use firm pressure for 15-20 seconds
• Peel carrier warm

Glitter Applies to:

100% cotton
Poly/cotton blends
100% polyester
Leather

Recommended Accessories:

Siser Weeder
PTFE Teflon Sheet 16" x 24"

Laundering:

Wait 24 hours before 1st wash
Machine wash warm or cold / mild detergent
Dry on normal dryer setting
Do not dry clean garments with glitter iron-on vinyl designs