Siser Brick 600 Heat Transfer Vinyl (HTV)
Application Instructions

Siser Brick 600 Cutter Settings

Cricut:

Blade: Standard
Setting: Cardstock Light+

Silhouette Cameo:

Blade: Standard, 10
Material: Heat Transfer, Flocked
Speed: 4
Force: 33

Scan N Cut:

Blade: Standard, 10
Cut Speed: 1
Cut Pressure: 2

Roland GS/GX-24:

Blade: 60°*
Gram Force: 150-190
Offset: .250
Speed: 30 cm/s

Graphtec:

Blade: 60°*
Gram Force: 11-12
Tool: CB09U+0
Speed: 25 cm/s

MH, SC2, LP3, and Titan 1:

Blade: 45°/60°
Gram Force: 120-130
Speed: 300mm/s
*Blade Advancing Varies

Titan 2 & 3:

Blade: 45°/60°
Gram Force: 100-110
Speed: 300mm/s
*Blade Advancing Varies

Settings may vary based on blade condition and age of machine. Always perform a test cut prior to cutting designs.
* For Roland & Graphtec cutters, due to the material thickness, extend the blade out so that a significant amount of blade is exposed.

Application Instructions

Application instructions (home iron)

Set iron dial between Cotton and Linen
Cover design with PTFE Teflon Sheet
Place on flat, hard surface (ironing board not recommended)
Press iron with medium/firm pressure (do not slide iron)
Press each section of design for 10-15 seconds
If areas of design lift after application, replace Teflon sheet and re-press for 10 seconds
Peel carrier cold