Holographic Heat Transfer Vinyl
Application Instructions

Cutter Settings

Cricut:

Blade: Standard
Setting: Light Cardstock

Silhouette Cameo:

Blade: Standard, 3
Material: Heat Transfer, Smooth
Speed: 8
Force: 14

Scan N Cut:

Blade: Standard, 2
Cut Speed: 1
Cut Pressure: 3

Roland GS/GX-24:

Blade: 45°
Gram Force: 180-190
Offset: .250
Speed: 30 cm/s

Graphtec:

Blade: 45°
Gram Force: 17-18
Tool: CB09U+0
Speed: 30 cm/s

MH, SC2, LP3, and Titan 1:

Blade: 45°/60°
Gram Force: 85-90
Speed: 300mm/s
*Blade Advancing Varies

Titan 2 & 3:

Blade: 45°/60°
Gram Force: 75-80
Speed: 300mm/s
*Blade Advancing Varies

Holographic HTV heat & cutting settings may vary based on blade condition and age of machine. We hope our Cricut and other cutter iron-on vinyl directions will help you create your designs.

Application Instructions

Application instructions (home iron)

Set iron dial between Cotton and Linen
Cover design with PTFE Teflon Sheet
Place on flat, hard surface (ironing board not recommended)
Press iron with medium/firm pressure (do not slide iron)
Press each section of design for 10-15 seconds
If areas of design lift after application, replace Teflon sheet and re-press for 5-10 seconds
Peel carrier cold