• (404) 720-5656
  • Mon - Fri 9AM - 5:00PM, Sat 9AM - 3PM
  • 925 Veterans Memorial Hwy SW, #150, Mableton, GA

EasyReflective® Heat Transfer Vinyl
Application Instructions

Cutter Settings

Cricut:

Blade: Standard
Setting: Iron-On

Silhouette Cameo:

Blade: Standard, 3
Material: Heat Transfer, Smooth
Speed: 8
Force: 6 

Scan N Cut:

Blade: Standard, 2
Cut Speed: 1
Cut Pressure: 1

Roland GS/GX-24:

Blade: 45°
Gram Force: 80-90
Offset: .250
Speed: 25-50 cm/s

Graphtec:

Blade: 45°
Gram Force: 9-10 
Tool: CB09U+0
Speed: 30 cm/s

MH, SC2, LP3, and Titan 1:

Blade: 45°/60°
Gram Force: 80-85
Speed: 300mm/s
*Blade Advancing Varies

Titan 2 & 3:

Blade: 45°/60°
Gram Force: 60-65
Speed: 300mm/s
*Blade Advancing Varies

Settings may vary based on blade condition and age of machine. Always perform a test cut prior to cutting designs.

Application Instructions

Application instructions (home iron)

  • Set iron dial between Cotton and Linen
  • Cover design with PTFE Teflon Sheet
  • Place on flat, hard surface (ironing board not recommended)
  • Press iron with medium/firm pressure (do not slide iron)
  • Press each section of design for 10-15 seconds
  • If areas of design lift after application, replace Teflon sheet and re-press for 10 seconds
  • Peel carrier warm

Application Instructions (heat press)

  • Cut in reverse
  • Weed excess material
  • Preheat garment for 2-3 seconds
  • Apply design at 305°F/150°C
  • Use medium pressure for 15 seconds
  • Peel carrier warm

Recommended Accessories & Care

EasyReflective Applies to:

100% cotton
Poly/cotton blends
100% polyester
Nylon (testing recommended)

Laundering:

Wait 24 hours before 1st wash
Machine wash warm or cold / mild detergent
Can be machine dried on low but hanging item to dry will preserve reflective quality
Do not dry clean

BACK TO TOP

Net Orders Checkout

Item Price Qty Total
Subtotal $0.00
Shipping
Total

Shipping Address

Shipping Methods